tsc-75w series dimmable led drivers constant current aluminum housing electrical specifcations input voltage range: 277 - 480 nom. vac (249 - 528 v min/max) frequency: 50/60 hz nom. (47-63 hz min/max) power factor: >0.90 @ full load, 277v through 480v inrush current: 135.0 amps max @ 480 vac, cold start 25oc input ac current: 0.34 a max 277vac, 0.21 a max 480vac maximum power: 75w line regulation: 1% load regulation: 3% thd: <_ 20% @ full load leakage current: 0.7 ma 480 vac 50hz typical effciency 85-87% at 480vac turn-on delay: 1 s typical output current ripple: 20% output protection: over-voltage, over-temperature, and short circuit protection environmental specifcations minimum starting temp: -40oc maximum case temp. 90c storage temperature: -40oc to +85oc humidity: 5% to 100% cooling: convection sound rating: class a mtbf: 380,000 hours (700 ma model) at 480vac input, 80% load and 25oc ambient conditions per mil-hdbk-217f lifetime: 50,000 hours @ case temperature = 60oc weight: 2.2 lbs. (1.0 kg) constant current - product specifcations model number output current (ma 5%) output voltage range (vdc) max. output power (w) typical effciency tsc-075s035st 350 107-214 75 87% tsc-075s070st 700 53-107 75 86% tsc-075s105st 1050 36-72 75 87% tsc-075s140st 1400 26-53 75 87% tsc-075s210st 2100 18-36 75 86% tsc-075s315st 3150 12-24 75 85% dimming versions - product specifcations model number output current (ma 5%) output voltage range (vdc) max. output power (w) typical effciency tsc-075s035dt 350 107-214 75 87% tsc-075s070dt 700 53-107 75 86% tsc-075s105dt 1050 36-72 75 87% TSC-075S140DT 1400 26-53 75 87% tsc-075s210dt 2100 18-36 75 86% tsc-075s315dt 3150 12-24 75 85% the output current is adjustable at factory from 50% to 100%. class 2: us/canada us only e332160 ? total power: 75 watts ? input voltage: 277-480 vac nom. ? ul dry, damp & wet location rated ? ip67 ? high power factor ? ul type hl rated * ul8750 rev 8-31-15 specifcations subject to change without notice. note: led drivers are designed and intended to operate led loads only. non-led loading may be outside the specifed design limits of our led drivers, and therefore cannot be covered by any warranty. if you desire to use our led drivers to operate non-led loads please contact us to discuss compatibility. thomas research products ? 1225 bowes rd ? elgin, il 60123 ? t 847-515-3057 ? f 847-515-3047 ? www.trpssl.com
pg 2 of 3 dimensions - mm tc = 90 c max ac input (3*awg18) black (acl) white (acn) green (gnd) dc ouput (2*awg18) red (v+) blue (v-) dimming control (3*awg22) purple (dim+) gray (dim-) black/white (vc) 505 505 302 51 402 502 65020 22020 23020 152 152 222 115 45 45 ?9.5 4.4 202 188 184 38.1 15 88.9 86 70 12 30 case temperature (c) lifetime (khrs) lifetime / case temperature 0 15 30 45 60 75 90 105 120 135 35 40 45 50 55 60 65 70 75 80 85 90 derating curve load (%) 100 80 60 40 20 0 ambient temperature (c) -10 0 10 20 30 40 50 60 70 50% normalized output voltage pf power factor / output voltage 60% 70% 80% 90% 100% 277 v a c 480 v a c 0.60 0.65 0.80 0.75 0.70 0.85 0.95 0.90 1.00 350ma model 75% 70% 80% 85% 90% 95% efficiency / load 50% normalized output voltage efficiency 60% 70% 80% 90% 100% 277 v a c 480 v a c tsc 75w series thomas research products ? 1225 bowes rd ? elgin, il 60123 ? t 847-515-3057 ? f 847-515-3047 ? www.trpssl.com ssl solutions faster than the speed of light ?
pg 3 of 3 dimming control notes: 1. the dimmer can also be replaced by an active 0-10v voltage source signal or passive components like resistors and zener. 2. the dimming signal is allowed to be less than 1v, when it is between 0 and 1v, the output level is 10%. 3. do not connect the gray wire (vdim-) to blue wire (v-) together. 4. the dimming section is not isolated from the output. 5. vc is an auxillary 12v/15ma output. 6. if 0-10v dimming is not used, dim+ can be either capped-off or connected to vc. parameters minimum typical maximum 12v output voltage 10.8 v 12 v 13.2 v vc source current 10 ma 15 ma 20 ma absolute maximum voltage on the 0~10v input pin -2 v 15 v source current on 0~10v input pin 150 a 200 a 250 a implementation with 0-10v dimming dim+ (purple) v+ (red) v- (blue) vc (black/white) vac l n g 0-10v dimmer dim- & vc return (gray) tsc-75xxxdt the dimmer control is operated from an input signal of 1 C 10 vdc. dimming voltage (v) normalized output current output current/dimming voltage 0% 20% 40% 60% 80% 100% 0 1 2 3 4 5 6 7 9 8 10 safety certifcation standard ul/cul ul8750, ul1310, ul1012, can/csa-c22.2 no. 223-m91, csa-c22.2 no. 107.1-01 ce en 61347-1, en61347-2-13 emc standard notes en 55015 conducted emission test & radiated emission test with 6 db margin en 61000-3-2 harmonic current emissions: class c en 61000-3-3 voltage fuctuations & ficker en 61000-4-2 electrostatic discharge (esd): 8 kv air discharge, 4 kv contact discharge level 3, criteria a en 61000-4-3 radio-frequency electromagnetic field susceptibility test-rs level 3, criteria a en 61000-4-4 electrical fast transient / burst-eft level 3, criteria a en 61000-4-5 surge immunity test: ac power line: line to line 4kv, line to earth 6 kv en 61000-4-6 conducted radio frequency disturbances test-cs level 3, criteria a en 61000-4-8 power frequency magnetic field test 3a/m , criteria a en 61000-4-11 voltage dips criteria b en 61547 electromagnetic immunity requirements applies to lighting equipment tsc 75w series note: thomas research products ? 1225 bowes rd ? elgin, il 60123 ? t 847-515-3057 ? f 847-515-3047 ? www.trpssl.com ssl solutions faster than the speed of light ?
|
